Sudo curl -LO /pi/setup-lcd.sh & sudo chmod +x setup-lcd.sh & sudo.
setup.sh Pixelcade LCD (use this also for Pixelcade LED + Pixelcade LCD) Sudo curl -LO /pi/setup.sh & sudo chmod +x setup.sh & sudo. For example, if you have Pixelcade LED, then run the Pixelcade LED installer script. Run the respective installer script below depending on if you have Pixelcade LED or Pixelcade LCD.
Use your original art pack code to re-install. Note: If you have purchased the Pixelcade Art Pack, you will need to re-install the art pack after updating the Pixelcade software on your Pi. Run the respective command to install Pixelcade for your Raspberry Pi.
Raspberry Pi Zero, Raspberry Pi 3 Series, and Raspberry Pi 4 are supported. A big thanks to Kai and Tony for developing the integrations with EmulationStation and Attract Mode respectively. Attract Mode support is experimental (see Attract Mode section below). Pixelcade supports RetroPie with the EmulationStation front end by default.
